|
Dr.Web NAP Validator checks health of anti-virus software on protected workstations. It is installed on the computer where a configured NAP server resides.
To install NAP Validator
| 1. | Run the installation file. In the dialog window, select the language to use during install. Select English and click Next. |
| 2. | On the Welcome page of the InstallShield Wizard, click Next. |
| 3. | On the License Agreement page, read the agreement. To accept the agreement and proceed with the installation, select I accept the terms of the license agreement and click Next. To exit the wizard, click Cancel. |
| 4. | On the next page, specify Enterprise Server IP Address and Port and click Next. |
| 5. | Click Install. The installation begins. |
| 6. | When installation completes, click Finish. |
After you install Dr.Web NAP Validator, add Enterprise Server to the trusted NAP servers group.
To add Dr.Web Enterprise Server to the trusted NAP servers group
| 1. | To open NAP server configuration component, run the nps.msc command. |
| 2. | In the Remediation Servers Group section, click Add. |
| 3. | In the dialog window, enter the name for the new remedial server and the Enterprise Server IP address. |
| 4. | Click OK to save changes. |
|